Linux – System load by HP-SNMP-Agents is high

hphp-proliantlinuxsnmp

After installing the hp-snmp-agents on my proliant server, I noticed the system load never goes below 1. Is this normal behavior, or is it possible to reduce the load of the HP tools?

Update: the server is a HP Proliant DL360 G3, running Linux.
The hp-snmp-agents package is version 8.2.0, installed from the smartstart CD.
System firmware is upgraded to 8.0

Best Answer

We'll want a bit of detail here, but I have a good idea of what your issue is. First, I'll assume that you're using Linux (due to the reference to load). Next, I'd like to know which version of the HP agents you're using. Are you using a version earlier than 8.60? If that's the case, the problem is probably due to the Lights-Out Driver agents.

In short, you'll want to stop the HP management agents with /etc/init.d/hp-snmp-agents stop. Edit the exclude line in /opt/hp/hp-snmp-agents/cma.conf from:

exclude
to
exclude cmasm2d cpqriisd cmarackd

Start your agents again with /etc/init.d/hp-snmp-agents start

Please see: http://h30499.www3.hp.com/t5/ProLiant-Servers-Netservers/Proliant-Support-Pack-8-20-gt-Load-always-at-1/td-p/1069560

Also respond with your details. Which Proliant model is this? These issues were resolved in the 8.60 variant of the agents. As usual, it will also make sense to update your firmware and use the newest version of the agents.

Proliant firmware and management software (by model).

Related Topic