Mikrotik IPV6 dhcp client

If 2 client connect to wireless network using same Wireless routers there is no problem but when 2 client connect with separate Wireless routers can not see themselves. For fix this problem, there is 2 ways:

1. Connect Wireless routers to LAN using their LAN Ports (Not using wan port). In this case wireless client get IP address in range 192.168.1.0/24

2. Set each wireless network address with a specific range, for example

   • wireless A has IP address in range 192.168.2.0/24
   • wireless A has IP address in range 192.168.3.0/24

   and set wireless WAN Ports IP address in mikrotik to make static for example

   • wireless A has IP address in range 192.168.1.10
   • wireless A has IP address in range 192.168.1.11

   Now when a client attempt to connect other client if IP address not in same range forward IP address to mikrotik.

In mikrotik

1. Masqurade local IP address to local IP address destinations
2. Add route to routing other range to their wireless router

It sounds like you may need to configure the firewall to pass through the NAT traffic on the Mikrotik. This is 'masquerading'.

When you enable NAT, by default the Mikrotik doesn't enable masquerading and as a result won't pass through established traffic. You must specifically enable the Firewall rule. An equivalent in IPTABLES would be the basic "allow all established" rule.

/ip firewall nat add chain=srcnat action=masquerade out-interface=Public

Where Public is the name of the interface on your WAN facing port (in your example with the 192.168.50.1 IP).

reference: http://wiki.mikrotik.com/wiki/Manual:IP/Firewall/NAT