Mikrotik, script

mikrotik

I have Mikrotik 3.3, I have a dyndns script, which not works, because of this line:

/tool fetch mode=http address="checkip.dyndns.org" src-path="/" 
dst-path="/dyndns.checkip.html"[/b]

bad-argument name src-path (line 1 column 52)

What can be the problem?

Best Answer

From the Wiki: http://wiki.mikrotik.com/wiki/Manual:Tools/Fetch

"Fetch is one of the console tools in Mikrotik RouterOS. It is used to copy files from any network device to a Mikrotik router via HTTP or FTP. In latest v5 versions it is possible also to upload files to remote locations."

src-path (string; Default: ) Title of the remote file you need to copy.

From what I gather here src-path needs to be a filename, not just "/". Try to rerun the command and specify a filename.

Related Solutions

Nat – How to configure a MikroTik hAP ac lite router as a Layer 2 switch

Just bridge every interface on hAP and it will act essentially as a switch.
That's it pretty much.

Then remove or disable any dhcp-server instances on IP > DHCP-Server.

Since you do not provide any configuration exports it's impossible to provide you with any commands on how to do the above since every mikrotik installation is kind of unique. You could have implemented your current setup in many different ways. We need to know your current configuration to be able to provide you with any commands.

DHCP relay has nothing to do with what you ask so don't confuse yourself with that.

Also, winbox works fine on Linux using Wine. That's the official way of running Winbox on non-windows machines.

Without winbox it just makes the whole procedure that much more difficult since you might lose access to mikrotik in order to change its IP to the FritzBox subnet (Winbox can find and connect to a mikrotik router even if it's not accessible via IP). If you don't understand what you are doing (blindly copying/pasting commands) you may end up having to reset the whole configuration to gain access again.

IMHO you should configure the FritzBox to act as a PPPoE bridge and use Mikrotik to dial (pppoe-client) to the ISP to establish the internet connection.

This way FritzBox will act as a modem and nothing more. And hAP will act as a powerful router. Having Mikrotik obtain the public IP you avoid double NATs and most importantly you can take advantage of all mikrotik's features. You can create very advanced configurations that I highly doubt that FritzBox (or any other consumer dsl modem for that matter) can do.

Switch – Mikrotik Switch Trunk (Tag All) Port

No need VLAN adding. Just create a bridge and attach ports 23 and 24 to that bridge. All traffic including tagged one will pass.

/interface bridge add name=bridge-trunk protocol=none
/interface bridge port add bridge=bridge-trunk interface=ether23
/interface bridge port add bridge=bridge-trunk interface=ether24

OR/If you have performance issues (CRS125 CPU going up when several 100'Mbps are passing), you can use the inboard switch chip, faster than bridge.

/interface ethernet set [ find name=ether24 ] master-port=ether23

Then eth24 will be enslaved to eth23 and the two ports will act like a simple switch.

If it does not work, just reset-config the CRS125 with "no-default" option to wipe out all messy config and re-do the previous commands.

Best Answer

Related Solutions

Nat – How to configure a MikroTik hAP ac lite router as a Layer 2 switch

Switch – Mikrotik Switch Trunk (Tag All) Port

Related Topic