I installed PFsense on VMware with two interfaces.
1.WAN -> 192.168.1.110 ->Bridge
Getaway->192.168.1.1=>Modem IP
2.LAN -> 10.1.1.1 ->LAN Segment
how config Nat and Route to access to Internet (from Host Connect to 10.1.1.1 interface )And Modem(or 192.168.1.0/24 rang IP) ?
Best Answer
Firewall -> NAT -> Outbound
There you can create a new rule for the WAN with source 10.1.1.0/24 and NAT address 'WAN address'.
This should automatically be done by pfsense if you assigned a WAN and LAN interface.
Also: Interfaces -> WAN
Make sure if you use static addresses that you have an IPv4 upstream Gateway set. If not, click on 'add a new one' and enter your gateway there.