hp hp-proliant sas sata – ProLiant DL380p Not Recognising HP Hard Drives on Boot

hphp-proliantsassata

I have two ProLiant DL380p rack mounted small factor servers. I have installed the following drives onto both servers:

  • 1x 240GB SSD drive (Crucial NOT HP branded)
  • 2.5" SATA 7.2k rpm 1TB (HP-branded) MM1000GBKAL
  • 2.5" SAS 10k rpm 600GB (HP-branded) EG0600FBVFP

When I boot the server and the HP boot screen appears it says the array controller only detected one logical drive. If I look at the drive bays it appears that only the SSD disk (the only non-HP branded disk!) is detected. When I use the HP provisioning-based install of Windows 2012 R2, it too only sees the 240GB SSD. Once Windows 2012 R2 is fully installed, it too only sees the SSD (in disk partition manager).

Could someone tell me why these hard drives are not being recognised? These are brand new and I have 6x of the 1TB drives and none of them get recognised.

I got the product code from the HP data-sheet telling me these drives were compatible so I don't understand why they are not being recognised? I have also tried different drive bays, but to no avail.

Strangely, if I run HP Insight Diagnostics, that does see and list the HP-branded disk as:

1.0 TB, SATA ATA MM1000GBKAL

PLEASE HELP!!

Best Answer

With regard to non-HP SSDs in ProLiant servers, nope... nope... nope... nope...

Anyway, this is an HP ProLiant server, so it has an onboard Smart Array RAID controller. In order to use the disks connected to that controller, you have to create a "logical drive". (here's a guide)

Please tap F8 to enter the HP Smart Array BIOS utility when prompted or use the HP Array Configuration Utility from the Intelligent Provisioning menu at POST (hit F10).

Also see: http://h20565.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c00729544

Related Topic