* Resolved by rolling back to DRAC6_FRMW_WIN_R279926.EXE *
Having an issue with a new R710 where I cannot enable IPv4 on the iDRAC card.
I have tried enabling IPv4 and setting static IP, Gateway ect however when saving the settings it fails. This has been done using the Dell Setup Disk & during boot (ctrl+E).
Dell OpenManage Server Administrator has been installed on the box which I can see the DRAC card is enabled (has mac address ect) but in the Remote Access – Additional Configuration menu I am not able to set IPv4 to enabled. Each time I click apply changes it reverts back to Disabled.
Bios ect are all up to date. Any help would be appreciated.
More Informatin;
Device Type: iDRAC6 Enterprise
IPMI Version: 2.0
System GUID: 4a35364f-c0c8-3480-3410-00364c4c4544
Number of Possible Active Sessions 5
Number of Current Active Sessions 0
Enable IPMI Over LAN: No
SOL Enabled: Yes
MAC Address: BC-30-5B-E9-CA-CF
Best Answer
its a new machine, why don't you contact dell support?