Routing WIFI and LAN for specific traffic

iplocal-area-networkmac-osxnetworkingrouting

I have two network devices aboard my macbook pro:

  1. WIFI (en1): Used for general traffic. Connects to an ip of 192.168.19.* via DHCP
  2. LAN (en0): Used for specific traffic. Connects to an ip of 192.168.2.10 as a static IP. Does not connect to a router, only a switch for direct routing connection.

I have 4 IP addresses I need to access on the LAN:

  1. 192.168.2.1
  2. 192.168.2.21
  3. 192.168.2.20
  4. 192.168.2.30

The rest of the traffic needs to go to WIFI. I have tried setting up a routing table for the specific ip addresses, but I only managed to mess up my network. I do not venture out into the world of networking too often, but this was the latest command I have been trying:

sudo route add -host 192.168.2.30 -interface en0

This command killed my ability to use ping. It told me that ping could not allocate memory (is that even possible)? It also killed my wifi access. Logging out and back in fixed the issue. I really do not mind to make this solution permanent, so I am fine with a temporary routing.

EDIT:

If I currently have been trying:

sudo route flush
sudo route add default 192.168.19.1

This gets everything to work for about a minute. But after such minute it "forgets" the routing to WiFi while retaining LAN's (en0) routing. If I unplug and replug my LAN (en0) cable, the process works for another minute.

EDIT 2:

These were some of commands entered as a request by d34dh0r53.

$ netstat -rn
Routing tables

Internet:
Destination        Gateway            Flags        Refs      Use   Netif Expire
default            192.168.2.1        UGSc            4        0     en0
default            192.168.19.1       UGScI           0        0     en1
127                127.0.0.1          UCS             0        1     lo0
127.0.0.1          127.0.0.1          UH              5  1429023     lo0
169.254            link#4             UCS             0        0     en0
192.168.2          link#4             UCS             4        0     en0
192.168.2.1        0:27:22:2e:5f:1a   UHLWIi          2        0     en0   1199
192.168.2.10       127.0.0.1          UHS             0        0     lo0
192.168.2.30       90:a2:da:0:f5:63   UHLWIi          1     1433     en0   1191
192.168.2.255      ff:ff:ff:ff:ff:ff  UHLWbI          0        7     en0
192.168.19         link#5             UCS             2        0     en1
192.168.19.1       3e:d0:f8:aa:28:56  UHLWIi          0        2     en1   1192
192.168.19.3       127.0.0.1          UHS             1        0     lo0
192.168.19.255     ff:ff:ff:ff:ff:ff  UHLWbI          0        5     en1

Internet6:
Destination                             Gateway                         Flags         Netif Expire
::1                                     link#1                          UHL             lo0
fe80::%lo0/64                           fe80::1%lo0                     UcI             lo0
fe80::1%lo0                             link#1                          UHLI            lo0
fe80::%en0/64                           link#4                          UCI             en0
fe80::226:4aff:fe00:b68a%en0            0:26:4a:0:b6:8a                 UHLI            lo0
fe80::%en1/64                           link#5                          UCI             en1
fe80::226:bbff:fe03:cbd%en1             0:26:bb:3:c:bd                  UHLI            lo0
ff01::%lo0/32                           fe80::1%lo0                     UmCI            lo0
ff01::%en0/32                           link#4                          UmCI            en0
ff01::%en1/32                           link#5                          UmCI            en1
ff02::%lo0/32                           fe80::1%lo0                     UmCI            lo0
ff02::%en0/32                           link#4                          UmCI            en0
ff02::%en1/32                           link#5                          UmCI            en1
$ traceroute -n 192.168.2.1
traceroute to 192.168.2.1 (192.168.2.1), 64 hops max, 52 byte packets
 1  192.168.2.1  2.499 ms  3.392 ms  3.829 ms
$ traceroute -n google.com
traceroute: unknown host google.com

Best Answer

You shouldn't need to create any routing rules by hand for that configuration, provided that all the 192.168.2.x addresses you want to communicate with are down the interface with the 192.168.2.x address.

  1. Go to System Preferences -> Network
  2. Select your Ethernet device, make sure "Configure IPv4" is set to "Manually", that your subnet mask is set to 255.255.255.0, and that the router box is empty.

Once this is done, netstat -rn should still show the routes for both of the subnets, but only a "link#4" route in place of the default route through 192.168.2.1.

If you don't want a default route, leave the router box blank. The value in the router box is only used to set up a default route through this network interface, and it isn't used for anything else.

Related Topic