Ssh – Cannot login to Cisco 2911 over ssh

ciscoiosnetworkingsshtcp

30 minutes ago my router is not accepting ssh connection. Well, ports is open (due to nmap), ssh simply hangs on reading from Cisco socket (observation from strace):

/home/rafal/.ssh/id_dsa-cert type -1
) = 60
open("/etc/passwd", O_RDONLY|O_CLOEXEC) = 4
_llseek(4, 0, [0], SEEK_CUR)            = 0
fstat64(4, {st_mode=S_IFREG|0644, st_size=2871, ...}) = 0
mmap2(NULL, 2871, PROT_READ, MAP_SHARED, 4, 0) = 0xb78cb000
_llseek(4, 2871, [2871], SEEK_SET)      = 0
munmap(0xb78cb000, 2871)                = 0
close(4)                                = 0
open("/etc/passwd", O_RDONLY|O_CLOEXEC) = 4
_llseek(4, 0, [0], SEEK_CUR)            = 0
fstat64(4, {st_mode=S_IFREG|0644, st_size=2871, ...}) = 0
mmap2(NULL, 2871, PROT_READ, MAP_SHARED, 4, 0) = 0xb78cb000
_llseek(4, 2871, [2871], SEEK_SET)      = 0
munmap(0xb78cb000, 2871)                = 0
close(4)                                = 0
rt_sigaction(SIGPIPE, NULL, {SIG_DFL, [], 0}, 8) = 0
rt_sigaction(SIGPIPE, {SIG_IGN, [], 0}, NULL, 8) = 0
read(3,

Where 3 is file descripor of connection with router (ESTABLISHED state, due to the netstat).

tcp        0      0 192.168.80.50:38954     192.168.81.1:22         ESTABLISHED 24839/ssh

One hour ago I was still able to connect. Now there is no more access trough the console port – what I should do?

Best Answer

So no SSH access, and no console access? I'm assuming telnet is not available?

Do you have access via SNMP (read/write community)? You could enable telnet via SNMP commands and see if that gets you in to the box?

You can use SNMP to execute other commands - but ultimately it sounds like you've hit something that is going to require a reload of the router. Either issue reload via SNMP access, or power cycle the box physically.

Edit: Other thoughts - if you get access to the box via Telnet or SNMP, you can "crypto key generate RSA" to re-generate your crypto keys. This may recycle the SSHD process on the router. Whatever you do, make sure you get a copy of the running-config before you reboot, or at least issue a copy run start to save any changes that were made to the box.

Related Topic