UDP – How to Stop UDP Attack

In our instance, our problem was solved by sysctl parameters, one different from Maciej.

Please note that I do not speak for the OP (buecking), I came on this post due to the problem being related by the basic detail (no multicast traffic in userland).

We have an application that reads data sent to four multicast addresses, and a unique port per multicast address, from an appliance that is (usually) connected directly to an interface on the receiving server.

We were attempting to deploy this software on a customer site when it mysteriously failed with no known reason. Attempts at debugging this software resulted in inspecting every system call, ultimately they all told us the same thing:

Our software asks for data, and the OS never provides any.

The multicast packet counter incremented, tcpdump showed the traffic reaching the box/specific interface, yet we couldn't do anything with it. SELinux was disabled, iptables was running but had no rules in any of the tables.

Stumped, we were.

In randomly poking around, we started thinking about the kernel parameters that sysctl handles, but none of the documented features was either particularly relevant, or if they had to do with multicast traffic, they were enabled. Oh, and ifconfig did list "MULTICAST" in the feature line (up, broadcast, running, multicast). Out of curiosity we looked at /etc/sysctl.conf. 'lo and behold, this customer's base image had a couple of extra lines added to it at the bottom.

In our case, the customer had set net.ipv4.all.rp_filter = 1. rp_filter is the Route Path filter, which (as I understand it) rejects all traffic that could not have possibly reached this box. Network subnet hopping, the thought being that the source IP is being spoofed.

Well, this server was on a 192.168.1/24 subnet and the appliance's source IP address for the multicast traffic was somewhere in the 10.* network. Thus, the filter was preventing the server from doing anything meaningful with the traffic.

A couple of tweaks approved by the customer; net.ipv4.eth0.rp_filter = 1 and net.ipv4.eth1.rp_filter = 0 and we were running happily.

To quote the nc man page:

-l Used to specify that nc should listen for an incoming connection rather than initiate a connection to a remote host. It is an error to use this option in conjunction with the -p, -s, or -z options. Additionally, any timeouts specified with the -w option are ignored.

The key here is that -p cannot be combined with the -l flag. When using the -l flag, any ports specified in the positional arguments are used. So instead, you could use the following:

netcat -ul 2115