This is driving me crazy.
I'm configuring the switch from the web interface.
Under: Switching > Ports > Port Configuration
I disable 'Auto Negotiation', I set the 'Admin Duplex' to 'FULL', I click on the 'Admin Port Speed' drop-down.. OOPS, only '10M' and '100M' are available.. does anyone knows where is the '1000M'?
If I set it to Auto Negotiation 'Enable', the port is well capable to work on 1000/Full, however I need to hard set the settings for a special device.
Has anyone seen this before?
(Firmware 3.2.1.3)
Best Answer
There is no "hard coded" option for gigabit ethernet. I believe that the protocol specification for 1000BASE-T dictates that it is available via auto-negotiation only.
From Wikipedia:
Which is itself referencing this IEEE PDF.