I am having some trouble with the web interface for my new E3800 (3800-48G-4SFP+ Switch (J9576A)). I have two of them stacked in a ring topology. When I restore to the factory default and add an IP address for my LAN to the DEFAULT_VLAN. I can connect and it works. Then after a bit of customizing the web interface stops working. I can't figure out why. My running-config is below. As you can see, I don't have any of the ports in the "back" VLAN. Any ideas? Thanks!
HP Stack E3800# sh run
Running configuration:
; hpStack Configuration Editor; Created on release #KA.15.03.3004
; Ver #01:00:01
hostname "HP Stack E3800"
time timezone -5
time daylight-time-rule Continental-US-and-Canada
stacking
member 1 type "J9576A" mac-address 082e5f-68xxxx
member 2 type "J9576A" mac-address 082e5f-68xxxx
exit
ip default-gateway 10.0.40.254
vlan 1
name "DEFAULT_VLAN"
untagged 1/1-1/52,2/1-2/52
ip address 10.0.40.247 255.255.255.0
exit
vlan 2
name "back"
no ip address
exit
ip authorized-managers 10.0.40.54 255.255.255.255 access manager
snmp-server community "public"
oobm
member 1
no ip address
exit
member 2
no ip address
exit
no ip address
ip default-gateway 10.0.40.254
exit
vlan 1
ipv6 mld
exit
vlan 2
ipv6 mld
exit
password manager
Best Answer
I found the answer!! I was configuring the OOBM interface which must automatically turn off the WebGui through the a VLAN. I needed to do the following;
disable the OOBM
enable "management-vlan 1"
Make my ip an authorized manager