We are developing a BLE sensor Peripheral to work with an iPad, that requires the following throughput of data on the BLE notification characteristic (no acknowledge) using a TI CC2541 BLE module and a custom profile:
One 20 bytes (GATT maximum standard packet) every 10ms, or since we appear to have a limit of 4 packets per connection interval, this equates to one connection interval every 40ms. Throughput required is 2,000 bytes per second, the TI website recommends the CC2541 BLE solution be used for several sensor devices requiring this level of data throughput.
The profile for the BLE module is set with min and max connection intervals of 20ms and 40ms respectively, which should suffice. The "Bluetooth Accessory Design Guidelines for Apple Products" document suggests that the minimum and maximum connection intervals we set, as above are correct. We are using the latest iPad and Apple tools for iOS 6 on a new Mac Mini / Mac Book.
With a simple test program on the iPad, we can get the link to work well sending 20 byte packets to the BLE Peripheral at intervals of 20ms, however once we lower this to 10ms as required we start loosing packets or getting corrupt packets, we have the FIFO empty interrupt turned off so we can handle the sending to the BLE module FIFO quicker, and we are using the maximum Baud rate of 230400 to send the 20 byte packets to the BLE TX FIFO from the micro.
We realise we are at the top end of the BLE transfer limit, and of what is possible. Can anyone advise if there is a solution to achieving 2000 bytes per second throughput using the TI CC2541 BLE chip / module with an up to date iPad?
Best Answer
We use TI 2540 (BLE stack version 1.3.2) succesfully with iPad/iPod/iPhone (iOS 6.x and 7.x). We currently send 75 notifications of 20 bytes per second => 1500 bytes/second. But I have tried to send 125 notifications and that worked as well.
Of course the more you send the greater likelihood of loosing data, e.g., less time to resend a NACK'ed message.
I have experienced that iOS' BLE stack may enter a mode where it begins to NACK messages continuously. If this happens you will loose a lot of messages. I have reported an error to Apple about this. (This problem seems to have been fixed in iOS 7.1.beta3/4.)
I currently have:
Yes, it doesn't conform with Apple's guidelines. But I believe they can be relaxed in our case.
UPDATE: I have also tried to use an iDevice as peripheral, i.e., BTLE between two iDevices. Here I have sent 150 messages per second without any problems.