Mysql – Can a foreign key reference a non-unique index

If you want to disable all constraints in the database just run this code:

-- disable all constraints
EXEC sp_MSforeachtable "ALTER TABLE ? NOCHECK CONSTRAINT all"

To switch them back on, run: (the print is optional of course and it is just listing the tables)

-- enable all constraints
exec sp_MSforeachtable @command1="print '?'", @command2="ALTER TABLE ? WITH CHECK CHECK CONSTRAINT all"

I find it useful when populating data from one database to another. It is much better approach than dropping constraints. As you mentioned it comes handy when dropping all the data in the database and repopulating it (say in test environment).

If you are deleting all the data you may find this solution to be helpful.

Also sometimes it is handy to disable all triggers as well, you can see the complete solution here.

Assuming three columns in the table: ID, NAME, ROLE

BAD: This will insert or replace all columns with new values for ID=1:

INSERT OR REPLACE INTO Employee (id, name, role) 
  VALUES (1, 'John Foo', 'CEO');

BAD: This will insert or replace 2 of the columns... the NAME column will be set to NULL or the default value:

INSERT OR REPLACE INTO Employee (id, role) 
  VALUES (1, 'code monkey');

GOOD: Use SQLite On conflict clause UPSERT support in SQLite! UPSERT syntax was added to SQLite with version 3.24.0!

UPSERT is a special syntax addition to INSERT that causes the INSERT to behave as an UPDATE or a no-op if the INSERT would violate a uniqueness constraint. UPSERT is not standard SQL. UPSERT in SQLite follows the syntax established by PostgreSQL.

GOOD but tedious: This will update 2 of the columns. When ID=1 exists, the NAME will be unaffected. When ID=1 does not exist, the name will be the default (NULL).

INSERT OR REPLACE INTO Employee (id, role, name) 
  VALUES (  1, 
            'code monkey',
            (SELECT name FROM Employee WHERE id = 1)
          );

This will update 2 of the columns. When ID=1 exists, the ROLE will be unaffected. When ID=1 does not exist, the role will be set to 'Benchwarmer' instead of the default value.

INSERT OR REPLACE INTO Employee (id, name, role) 
  VALUES (  1, 
            'Susan Bar',
            COALESCE((SELECT role FROM Employee WHERE id = 1), 'Benchwarmer')
          );