.net – Failed to CoCreate Profiler error – but not using a profiler

There is actually a (subtle) difference between the two. Imagine you have the following code in File1.cs:

// File1.cs
using System;
namespace Outer.Inner
{
    class Foo
    {
        static void Bar()
        {
            double d = Math.PI;
        }
    }
}

Now imagine that someone adds another file (File2.cs) to the project that looks like this:

// File2.cs
namespace Outer
{
    class Math
    {
    }
}

The compiler searches Outer before looking at those using directives outside the namespace, so it finds Outer.Math instead of System.Math. Unfortunately (or perhaps fortunately?), Outer.Math has no PI member, so File1 is now broken.

This changes if you put the using inside your namespace declaration, as follows:

// File1b.cs
namespace Outer.Inner
{
    using System;
    class Foo
    {
        static void Bar()
        {
            double d = Math.PI;
        }
    }
}

Now the compiler searches System before searching Outer, finds System.Math, and all is well.

Some would argue that Math might be a bad name for a user-defined class, since there's already one in System; the point here is just that there is a difference, and it affects the maintainability of your code.

It's also interesting to note what happens if Foo is in namespace Outer, rather than Outer.Inner. In that case, adding Outer.Math in File2 breaks File1 regardless of where the using goes. This implies that the compiler searches the innermost enclosing namespace before it looks at any using directive.

Start debugging, as soon as you've arrived at a breakpoint or used Debug > Break All, use Debug > Windows > Modules. You'll see a list of all the assemblies that are loaded into the process. Locate the one you want to get debug info for. Right-click it and select Symbol Load Information. You'll get a dialog that lists all the directories where it looked for the .pdb file for the assembly. Verify that list against the actual .pdb location. Make sure it doesn't find an old one.

In normal projects, the assembly and its .pdb file should always have been copied by the IDE into the same folder as your .exe, i.e. the bin\Debug folder of your project. Make sure you remove one from the GAC if you've been playing with it.