Linux – How to ‘grep’ a continuous stream

For BSD or GNU grep you can use -B num to set how many lines before the match and -A num for the number of lines after the match.

grep -B 3 -A 2 foo README.txt

If you want the same number of lines before and after you can use -C num.

grep -C 3 foo README.txt

This will show 3 lines before and 3 lines after.

To check if a directory exists in a shell script, you can use the following:

if [ -d "$DIRECTORY" ]; then
  # Control will enter here if $DIRECTORY exists.
fi

Or to check if a directory doesn't exist:

if [ ! -d "$DIRECTORY" ]; then
  # Control will enter here if $DIRECTORY doesn't exist.
fi

However, as Jon Ericson points out, subsequent commands may not work as intended if you do not take into account that a symbolic link to a directory will also pass this check. E.g. running this:

ln -s "$ACTUAL_DIR" "$SYMLINK"
if [ -d "$SYMLINK" ]; then 
  rmdir "$SYMLINK" 
fi

Will produce the error message:

rmdir: failed to remove `symlink': Not a directory

So symbolic links may have to be treated differently, if subsequent commands expect directories:

if [ -d "$LINK_OR_DIR" ]; then 
  if [ -L "$LINK_OR_DIR" ]; then
    # It is a symlink!
    # Symbolic link specific commands go here.
    rm "$LINK_OR_DIR"
  else
    # It's a directory!
    # Directory command goes here.
    rmdir "$LINK_OR_DIR"
  fi
fi

Take particular note of the double-quotes used to wrap the variables. The reason for this is explained by 8jean in another answer.

If the variables contain spaces or other unusual characters it will probably cause the script to fail.