I'm trying to make a an 10 watt stereo amplifier with bass, treble and volume control. I found the schematic of a 10 watt amplifier ( first image ) and a schematic for for the bass, treble and volume control ( 2nd image) my question is how do i combine the 2?
where do i connect the 1st circuit to the 2nd circuit?
Electrical – Amplifier with bass, treble and volume contol
amplifierstereo
Related Topic
- Electronic – Hi-Fi Stereo Amplifier gain regulation with potentiometer
- Electronic – How to decrease distortion/noise of LM386 amplifier at max gain and volume
- Electronic – Headphone amplifier for guitar with stereo MP3 input – mixing
- Electronic – Best way to connect balanced audio line to ADC (with volume pot)
Best Answer
simulate this circuit – Schematic created using CircuitLab
Figure 1. Preamplifier to power amplifier connection is simply a matter of connecting the outputs of one to the inputs of the other.
One odd thing is that the pots are wired backwards on the BA5406 schematic. Normally they are wired as shown in Figure 1 but this requires log pots (audio taper) so that loudness increases smoothly with rotation. The backwards pots may be a trick to use cheaper linear pots and still give an approximately log response. They actually short out the preamplifier when turned down to zero which is unusual but not dangerous.