Electronic – Calculating max wattage load for opto-triac

1. As others have noted in the comments, the voltage is not high enough. Assuming the WD1 output is a relay, you might be able to get rid of the indicator LED and use that circuit, perhaps with an indicator light across the pump motor. Alternately, use a 5V wall wart supply and increase R1 to get the proper current.

2. The triac drive circuit looks okay, suggest a higher value for C1, maybe 0.1uF with appropriate AC voltage rating.

3. Fuse placement should be in the 'hot' line- it's not clear if that's what you have done.

4. Heating will be around 7-10W so you need a fat heatsink for the triac. Note that the 8A BT137 is grossly underrated for a 7.5A motor load and will probably fail 'on' at the first opportunity. Suggest using at least a 25A triac (40A would not be too excessive) and giving it a large heatsink.

This is a cool circuit.

The power supply formed by D1, D2, C1, C2, R3 provides a semi-regulated voltage of about -14.4 Vdc. It can't supply very much current - about 5 mA continuous. That means that the opto can't be turned on continuously but instead must turn on only when needed to supply a short pulse to the gate of the triac.

Because this is a triac, it remains conducting after the gate pulse goes away so long as the current through the triac remains above the holding current.

Assuming that the reservoir cap C1 is fully charged, the peak gate current is about 55 mA. I actually consider that to be on the low side but should be fine so long as this circuit is operated at room temperature. I would expect the triac to NOT fire reliably outdoors in the winter (-30C or colder).

The reason this circuit works is that the supply voltage is negative with respect the triac's MT1 terminal. The opto emitter lead and the transistor emitter lead are both more negative than the collectors, which means that the transistors operate normally with full current gain.

The triac will conduct on both cycles of the incoming AC Mains supply so long as the gate pulses are short enough that the reservoir cap maintains close to full charge. In other words, the triac is triggered in quadrants 2 & 3: MT2 (+), Gate (-) and MT2 (-), gate (-).