connectoridentification
I am trying to find a male component that will fit the female component described and pictured below. Unfortunately I do not have the male end to provide pictures of. Any help identifying this connector or any tips for identifying connectors are much appreciated.
40-pin
20.3mm long
3.2mm wide
These are Molex PicoBlade series. The distance between pins (pitch) should be 1.25mm.
Crimp terminal (on tape)
Both manufacturers have assumed that whatever will be plugged into the other end of their connector will have both ground pins fitted & connected together (usually a safe assumption).
They therefore assume that they can save 1 or 2c on each unit by only fitting 1 ground pin.
Unfortunately for you, they each picked a different pin to fit.
If you have any access to the back of one of the connectors, you may be able to gently tease the ground pin out of the hole its presently in (you may need to depress/bend some little tabs on the side of the pin) and fit it back into the other hole such that it now lines up with its mate in the other connector.
Best Answer
As @EugeneSh. said, it is most likely a standard 20x2 rectangular 1mm pitch connector.
The female part could be compatible with these:
SAM9228-ND
And the male part could be compatible with these:
455-1868-1-ND
Although it's difficult to tell from your picture whether that's raised enough to accept the shroud on the linked part.