I have broken power supply for PC, 400W. A capacitor has failed. I don't have the same capacitor. The one I want to replace is 220μF 25V, and the one that I have to replace it with is 220μF 16V. Would there be any problem with this?
Electronic – replace a capacitor with one of lower voltage
capacitormaximum-ratingspower supplyvoltage
Related Topic
- Electronic – Electrolytic Capacitor Voltage Rating vs capacitance
- Electrical – Motor Control board -replace capacitor with higher voltage
- Electronic – How to figure out if a 25V capacitor can replace 50V in this circuit
- Electronic – How to replace electrolytic capacitors with non-electrolytic ones
- Electronic – Replace ONE 25v 47uf capacitor with FIVE 60v 10uf capacitors parallel
Best Answer
Capacitor's voltage rating is a very tricky thing. In the event of overvoltage, electrolytics like to fail rather unfortunately. It may simply cause physical electrolyte leakage that renders the cap inoperable. That's why these components are derated in the design stage.
However, since your cap is probably on the 12 Volt rail, there's still a 4-Volt margin. Not much if you ask me (switch mode spikes might be dangerously close to 16V).
Another thing to consider is the ESR rating. Power supplies are very often relying on low-ESR capacitors. Pushing more current through "regular" caps may/will degrade their lifespan.
I'd just go to your nearest electronics supplier and get a 25V lowish-ESR cap.