I am doing my own development board using LPC1343.I gone through the application note AN10986.I noticed the topic "Automating USB ISP".In that they described about USB softconnect. Now I am designing the board,a question arises whether is it necessary to use that softconnect or manual working is enough?….and also how much voltage(minimum) should be supplied to the VUSB pin to detect as USB ISP.
Is softconnect is necessary in lpc1343
armlpcmicrocontrollerusb device
Related Topic
- Startup sequence for lpc1343
- LPC1343 evaluation board USB bootloader not working
- With LPC1343 (ARM Cortex M3), how to control the the initial state of the MAT output from the timer
- Electronic – Using LPCxpresso with barebones LPC4337 board
- Electronic – Necessary things in LPC1343 basic development board
- Electronic – ST-Link debugger/programmer failed to find STM32L152 MCU on designed PCB
Best Answer
You don't need to use the softconnect if you don't want to. The manual method will work perfectly fine.
The VBUS pin is usually set at 5V as that is the standard voltage for the USB power lines. The controller will be looking for that voltage.