I'm getting another error in OrCAD when I try to create the netlist. When I try to create the netlist I get this warning:
- ERROR(ORCAP-36022): Pin number missing from Pin "DRIVE" of Package 100301_7 , U10A: SCHEMATIC1, PAGE1 (6.37, 0.95). All pins should be
numbered.- ERROR(ORCAP-36022): Pin number missing from Pin "BAT" of Package 100301_7 , U10A: SCHEMATIC1, PAGE1 (6.37, 0.95). All pins should be
numbered.- ERROR(ORCAP-36022): Pin number missing from Pin "SENSE" of Package 100301_7 , U10A: SCHEMATIC1, PAGE1 (6.37, 0.95). All pins should be
numbered.- ERROR(ORCAP-36022): Pin number missing from Pin "TIMER" of Package 100301_7 , U10A: SCHEMATIC1, PAGE1 (6.37, 0.95). All pins should be
numbered.- ERROR(ORCAP-36022): Pin number missing from Pin "!SHDN" of Package 100301_7 , U10A: SCHEMATIC1, PAGE1 (6.37, 0.95). All pins should be
numbered.- ERROR(ORCAP-36022): Pin number missing from Pin "PAUSE" of Package 100301_7 , U10A: SCHEMATIC1, PAGE1 (6.37, 0.95). All pins should be
numbered.
There is a total of 35 instances of this error. I don't understand the error though. If I go into edit part for U10A, all the pins are already numbered. So I don't see where else these pins should be numbered?
Best Answer
Does your part have both pin names and pin numbers like this? In the case of the picture below the numbers inside the part are the pin names and the numbers on the pins are the pin numbers.