Assuming three columns in the table: ID, NAME, ROLE
BAD: This will insert or replace all columns with new values for ID=1:
INSERT OR REPLACE INTO Employee (id, name, role)
VALUES (1, 'John Foo', 'CEO');
BAD: This will insert or replace 2 of the columns... the NAME column will be set to NULL or the default value:
INSERT OR REPLACE INTO Employee (id, role)
VALUES (1, 'code monkey');
GOOD: Use SQLite On conflict clause
UPSERT support in SQLite! UPSERT syntax was added to SQLite with version 3.24.0!
UPSERT is a special syntax addition to INSERT that causes the INSERT to behave as an UPDATE or a no-op if the INSERT would violate a uniqueness constraint. UPSERT is not standard SQL. UPSERT in SQLite follows the syntax established by PostgreSQL.
GOOD but tedious: This will update 2 of the columns.
When ID=1 exists, the NAME will be unaffected.
When ID=1 does not exist, the name will be the default (NULL).
INSERT OR REPLACE INTO Employee (id, role, name)
VALUES ( 1,
'code monkey',
(SELECT name FROM Employee WHERE id = 1)
);
This will update 2 of the columns.
When ID=1 exists, the ROLE will be unaffected.
When ID=1 does not exist, the role will be set to 'Benchwarmer' instead of the default value.
INSERT OR REPLACE INTO Employee (id, name, role)
VALUES ( 1,
'Susan Bar',
COALESCE((SELECT role FROM Employee WHERE id = 1), 'Benchwarmer')
);
Best Answer
Not a LINQ issue. If you need them for your schema, then use them. If you don't, don't. Either way, LINQ will handle your schema just fine.
One area that LINQ to SQL doesn't handle well are multy column / key mapping table that are used to connect a many to many relationship but I wouldn't say this strickly falls under the category that your question addresses. You can still perform CRUD operations on a mapping table within LINQ but LINQ cannot walk the relationship presented by a many to many mapping table. (LINQ works fine with one to one and one to many tables.)
I can't speak to any issue with the Entity Framework but again, I would be very surprised if the EF had any issues with multi-column / multi-key tables.