Above is the circuit with my attempt and how I viewed it. I'm wondering if there's anyone that can confirm if I got it right? The middle red line that goes through the Not gate confuses me.
Any help would be very appreciated!
Electrical – Write logic gate equation from circuit
circuit-designdigital-logicmath
Related Solutions
I entered your truth table into Logisim's combinational analysis window and got this. Is that what you're looking for?
As far as having two bits of state, it doesn't really matter so long as the outcome is the same. I just used S0 and S1 for the old state and BCar and CCar for the Input. New0 and New1 are the new output state.
There is no model for that component. What you can do is to model it as explained here.
Related Topic
- Electronic – need logic gate output higher than vcc
- Electronic – NAND Gate Logic Optimization
- Electrical – Logic Gate Power in Proteus
- Electronic – Pull-down resistors on logic gate and decoder inputs
- Electronic – Multiple Switch Equation to NAND Only equation
- Electronic – Basic Logic Gate with a Counter
Best Answer
Yes your answer looks good.
You are right, lines crossing without dots is hard to read sometimes, but when they cross completely like that assume they are not connected. Nobody, in their right mind, would draw two 90 degree bends knee to knee.