I'm reading an assembly language book. The problem with this book is that it tries to explain how a ram works with a CPU, but it doesn't explain in depth.
I would like to know how a memory cell, address line, and data pin work when storing or retrieving data.
Best Answer
All memory cells have their level, either
0or1. The CPU tells the memory device which cells it needs the binary values of, and supplies this address to the memory device. Inside the memory device the address is decoded in a row and column address, and the cell at that position in the matrix is allowed to gets its data to the databus, i.e. the data pin.Let's say we have an 8-bit address
01100101. This will be split up in a row address0110(the high order nibble) and a column address0101(the low order nibble). The row address selects row #06, so all cells connected to this row will have their data ready. The column address selects the cell at column #05 of this row, so that finally only one single cell is allowed to place its data to the output pin.Storing data follows the same pattern: only one row is selected, and the cell at the given column in that row will get the data present on the pin stored.
This is for 1 bit. The operation occurs for the full data word width simultaneously, so if you have a byte-wide memory, 8 bits are retrieved and their value placed on 8 databus pins.
edit
This picture should help you seeing things better:
This is a representation of a DRAM array, where data is stored in the charge of the capacitors, each capacitor is one bit. The row part of the address (here A1..A0) selects a row, which means they activate all FETs on that row, so that the levels of the capacitors for that row become available on their corresponding column. Then the column address selection block, controlled by the other part of the address, A3..A2, selects the one bit which we want the data from.
DRAM is easy to build, but has a nasty disadvantage: reading the data discharges the capacitor, so the data is lost. To counter this DRAM has sense amplifiers, which detect the current memory cell status and refresh it when read. In addition this refresh has to be done periodically because the capacitors' charge will leak away even when the memory isn't read. The need for refresh circuitry is easily compensated for thanks to the DRAM's cells' compactness.
SRAM uses a couple of transistors to store the data, and it isn't volatile in the way DRAM is (though the data is still gone when you switch the power off). With EEPROM and Flash the data is stored in the (insulated) floating gate of a FET, and therefore it won't lose its data when power is switched off.
Further reading:
This answer about data retention in Flash memory.